Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 246)

Call Control Commands
Incoming Call Bearer +CICB
©Restricted
Page: 56 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 2 August 23, 2007
12.12 Incoming Call Bearer +CICB
12.12.1 Description
This Wavecom proprietary command is used to set the type of incoming calls when
no incoming bearer is specified (see +CSNS).
Note:
Setting the +CICB command affects the current value of +CSNS.
12.12.2 Syntax
Action command
AT+CICB=<mode>
OK
Read command
AT+CICB?
+CICB: <mode>
OK
Test command
AT+CICB=?
+CICB: (list of supported <mode>s)
OK
12.12.3 Parameters and Defined Values
<mode>:
default incoming call bearer
0 data
1 fax
2 speech (default value)
12.12.4 Parameter Storage
The <mode> parameter is stored in EEPROM using AT&W command. The default
value can be restored using AT&F.