Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 67)

Global Configuration Commands
Auto Shutdown: +WASR
©Restricted Page: 61 / 184
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 1 August 23, 2007
6.4.3 Defined Values
<mode>: requested operation
0 disable the auto shutdown feature on <uart>
if <uart> is missing, all the available ports status will be
disabled
1 enable the auto shutdown feature on <uart> using the
GPIO <GpioId> and the wake-up time <timing>
if <uart>, <GpioId> and/or <timing> are missing, the
current values (the previous values set) will be used
2 get the auto shutdown feature status on <uart>
if <uart> is missing, all the available ports status will be
listed.
<uart>: UART port identifier
1 UART1
Note: Currently only UART1 supports the Auto Shutdown
Feature
<GpioId>: GPIO name
1 to 44 GPIO Id
range: 1-44 (default value: 24)
If this parameter is missing, the current setting will be
used.
<timing>: wake-up time of the external transceiver
t1 time delay to wake up the UART transceiver before
displaying the unsolicited response in 30 micro second
(μs) steps
range: 1-15 (default value: 6 (180μs))
If this parameter is missing, the current setting will be
used
<status>: current functionality status
0 auto shutdown feature disabled on <uart>
(default value)
1 auto shutdown feature enabled on <uart>