Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) User Manual
Page 146
Serial Port Commands
DTE-DCE Character Framing +ICF
©Restricted
Page:
140 / 184
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001
VOLUME 1
August 23, 2007
8.3.5
Examples
Command
Responses
AT+ICF=?
+ICF: (1-6),(0-4)
OK
Note: Possible values
AT+ICF=2,0
OK
Note: New values
AT+ICF?
+ICF: 2,0
OK
Note: Current values
8.3.6
Notes
All framing settings of the serial interface (i.e 801, 8E1, 8S1, 8N1, 7N1, 7O1, 7E1,
7S1 and 7N2) are supported for autobaud mode.
If USB port is used:
• the action command is supported for compatibility reasons (but without effect),
• the response to the action command and the read command behaviour is the
same as if sent on UART1 or UART2. See the section Managing the USB
feature of the "Appendixes to AT Commands Interface Guide" for the supported
USB emulated serial port settings.