Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 235)

Call Control Commands
Hang-Up Command H
©Restricted
Page: 45 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 2 August 23, 2007
12.6 Hang-Up Command H
12.6.1 Description
The ATH (or ATH0) command is used by the application to disconnect the remote
user. In the case of multiple calls, all calls are released (active, on-hold and waiting
calls).
The Wavecom proprietary ATH1 command has been added to disconnect the current
outgoing call, only in dialing or alerting state (i.e. ATH1 can be used only after the
ATD command, and before its terminal response (OK, NO CARRIER, …). It can be
useful in the case of multiple calls.
12.6.2 Syntax
Action command
ATH[<n>]
OK
Read command
None
Test command
None
12.6.3 Parameters and Defined Values
<n>:
disconnection type
0 ask for disconnection
1 ask for outgoing call disconnection
12.6.4 Parameter Storage
None.