Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 644)

Battery Commands
Wavecom Battery Charge Management +WBCM
©Restricted
Page: 96 / 158
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 4 August 23, 2007
<BatteryPulseChargingTimeout>: maximum duration in minutes of the pulse
charging
range: 60-90 (default value: 90)
<BatteryFastChargingTimeout>: maximum duration in minutes of the constant
current charge
range: 60-90 (default value: 90)
<Status1>: battery status returned by AT+WBCM=2
command
2 battery currently in charge, the <BattLevel>
parameter is also present
3 battery currently out of charge, the <BattLevel>
parameter is also present
<Status2>: battery status returned as +WBCI unsolicited
response
0 minimum battery level reached. The battery is
considered as discharged
The product is turned off (as with the +CPOF
command) if a charger is not plugged. Else the
charge automatically begins
not dependent on the parameter <ChargeInd>
1 maximum battery level reached (the battery is
considered as charged) or charging
discontinuation
The battery charging is stopped
not dependent on the parameter <ChargeInd>
2 battery currently in charge, the <BattLevel>
parameter is also present
3 battery currently out of charge, the <BattLevel>
parameter is also present
4 charger has been plugged, appears only when
<ChargeInd> is set to 2
5 charger has been unplugged, appears only when
<ChargeInd> is set to 2
6 unusual voltage or temperature (Li-ion charging
algorithm only), appears only when
<ChargeInd> is set to 2
<BattLevel>: current battery voltage in mV during or out of
charging
range: 2800-4300