Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 149)

Serial Port Commands
Result Code Suppression Q
©Restricted Page: 143 / 184
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 1 August 23, 2007
8.5 Result Code Suppression Q
8.5.1 Description
This command determines whether the mobile equipment sends result codes or not.
8.5.2 Syntax
Action command
ATQ[<n>]
[OK]
Read command
None
Test command
None
8.5.3 Parameters and Defined Values
<n>: result code transmission parameter
0 DCE transmits result codes.
1 Result codes are suppressed and not transmitted (default value).
8.5.4 Parameter Storage
The <n> parameter is stored in EEPROM using AT&W command. The default value
can be restored using AT&F.
8.5.5 Examples
Command Responses
ATQ0
Note: DCE transmits result codes
OK
Note: Command valid
ATQ1
Note: Result codes are suppressed and not
transmitted
Note: No response