Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 631)

I/O Commands
Write GPIO value +WIOW
©Restricted
Page: 83 / 158
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 4 August 23, 2007
22.3.5 Examples
Command Responses
AT+WIOW=2,0
Note: Sets I/O (number 2) to low
OK
Note: GPIO state is written
22.3.6 Notes
By default (e.g. after a reset), the I/O ports configuration is set by the +WIOM
command.