Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 210)

GSM Network Commands
Wavecom Multi-band Selection Command +WMBS
©Restricted
Page: 20 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 2 August 23, 2007
11.4.3 Parameters and Defined Values
<Band>: band frequency configuration
0 mono-band mode 850 MHz
1 mono-band mode 900 extended MHz (900E)
2 mono-band mode 1800 MHz
3 mono-band mode 1900 MHz
4 dual-band mode 850/1900 MHz
5 dual-band mode 900E (extended) / 1800 MHz
6 dual-band mode 900E (extended) / 1900 MHz
<Param>: type of change
0 The Wireless CPU ® will have to be reset to start on
specified band(s).
<ResetFlag> is set to 1.
default value if omitted
1 The change is effective immediately: the GSM stack is
restarted with specified band(s).
<ResetFlag> is set to 0.
This mode is forbidden while in communication and
during Wireless CPU ® initialization.
<ResetFlag>: reset flag
0 The feature was not modified since the last boot of the
product.
1 The feature has been modified since the last boot of the
product: it has to be reset in order to take the modification
into account.
11.4.4 Parameter Storage
The <Band> parameter is stored without using AT&W command.