Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 49)

Open AT ® Commands
Wavecom Open AT ® Control Command +WOPEN
©Restricted Page: 43 / 184
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 1 August 23, 2007
5.2.4 Parameter storage
The <Mode>, <A&Dsize>, <Key1> and <Key2> parameters are stored in EEPROM
without using the AT&W command. The default value can be restored using AT&F.
5.2.5 Examples
Command Responses
AT+WOPEN=? +WOPEN: (0-8),(0-1344),(0-24),(0-24)
OK
AT+WOPEN? +WOPEN: 0
OK
AT+WOPEN=2
Note: Get the Open AT ® library versions
+WOPEN: 2,"AT v03.01","AT v02.10"
OK
Note: Open AT ® version 2.10 application downloaded.
AT+WOPEN=7 +WOPEN: 7,0
OK
Note: Open AT ® application not started
AT+WOPEN=1 +CME ERROR: 541
Note: since main versions do not match, the Open AT ®
application can not be started.
AT+WOPEN=2
Note: Get the Open AT ® library versions
+WOPEN: 2,"AT v2.00","AT v2.00"
OK
Note: Open AT ® v2.00 library version. An embedded
application has been downloaded on this product..
AT+WOPEN=3 OK
Note: The flash objects are erased
AT+WOPEN=1
Note: Start the embedded application.
OK
+WIND: 3
Note: Product resets in order to start the embedded
application.