Teledyne 6200T - Sulfides Analyzer - Manual (Page 114)

Setup Menu Model 6200T Total Sulfur Analyzer
Teledyne Analytical Instruments 114
To access and navigate the VARS menu, use the following button sequence.
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
SAMPLE* RANGE = 500.000 PPB SO2 =X.XXX
< TST TST > CAL SETUP
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SETUP X.X 0 ) DAS_HOLD_OFF= 15.0 Minutes
NEXT JUMP EDIT PRNT EXIT
SETUP X.X 1 ) TPC_ENABLE=ON
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X ENTER VARS PASS: 818
8 1 8 ENTR EXIT
SETUP X.X DAS_HOLD_OFF=15.0 Minutes
1 5 .0 ENTR EXIT
SETUP X.X 2)RCELL_SET= 50.0 DegC
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X 3) IZS_SET= 50.0 DegC
PREV NEXT JUMP EDIT PRNT EXIT
DO NOT change
theses set-points
unless
specifically
instructed to by
TAI Customer
Service.
SETUP X.X CLOCK_ADJ=0 Sec/Day
+ 0 0 ENTR EXIT
SETUP X.X 7) CLOCK_ADJ=0 Sec/Day
PREV NEXT JUMP EDIT PRNT EXIT
EXIT ignores the new setting.
ENTR accepts the new setting.
SETUP X.X TPC_ENABLE=ON
ON ENTR EXIT
SETUP X.X 4 ) DYN_ZERO=ON
PREV NEXT JUMP EDIT PRNT EXIT SETUP X.X DYN_ZERO=ON
ON ENTR EXIT
Toggle to change setting
Toggle to change setting SETUP X.X 5) DYN_SPAN=ON
PREV NEXT JUMP EDIT PRNT EXIT SETUP X.X DYN_SPAN=ON
ON ENTR EXIT
Toggle to change setting
Toggle to change setting
Toggle to change setting
SETUP X.X CONC_PRECUISION : 3
AUTO 0 1 2 3 4 ENTR EXIT
SETUP X.X 6) CONC_PRECISION : 3
PREV NEXT JUMP EDIT PRNT EXIT
Toggle to change setting
Figure 5-15: SETUP – VARS Menu