Teledyne 6200T - Sulfides Analyzer - Manual (Page 180)

Remote Operation Model 6200T Total Sulfur Analyzer
Teledyne Analytical Instruments 180
8.2.2. Help Commands in Terminal Mode
Table 8-3: Terminal Mode Software Commands
Command Function
Control-T Switches the analyzer to terminal mode (echo, edit). If mode flags 1 & 2 are OFF, the interface can be
used in interactive mode with a terminal emulation program.
Control-C Switches the analyzer to computer mode (no echo, no edit).
CR
(carriage return)
A carriage return is required after each command line is typed into the terminal/computer. The command
will not be sent to the analyzer to be executed until this is done. On personal computers, this is achieved
by pressing the ENTER button.
BS
(backspace)
Erases one character to the left of the cursor location.
ESC
(escape)
Erases the entire command line.
? [ID] CR This command prints a complete list of available commands along with the definitions of their functionality
to the display device of the terminal or computer being used. The ID number of the analyzer is only
necessary if multiple analyzers are on the same communications line, such as the multi-drop setup.
Control-C Pauses the listing of commands.
Control-P Restarts the listing of commands.
8.2.3. Command Syntax
Commands are not case-sensitive and all arguments within one command (i.e. ID
numbers, keywords, data values, etc.) must be separated with a space character.
All Commands follow the syntax:
X [ID] COMMAND <CR>
Where:
X is the command type (one letter) that defines the type of command. Allowed
designators are listed in Table 6-25 and Appendix A-6.
[ID] is the analyzer identification number (refer to Section 6.10.1.). Example: the
Command “? 200” followed by a carriage return would print the list of
available commands for the revision of software currently installed in the
instrument assigned ID Number 200.
COMMAND is the command designator: This string is the name of the command being
issued (LIST, ABORT, NAME, EXIT, etc.). Some commands may have
additional arguments that define how the command is to be executed.
Press? <CR> or refer to Appendix A-6 for a list of available command
designators.
<CR> is a carriage return. All commands must be terminated by a carriage return
(usually achieved by pressing the ENTER button on a computer).
Table 8-4: Command Types
COMMAND COMMAND TYPE
C Calibration
D Diagnostic
L Logon
T Test
measurement
V Variable
W Warning