Teledyne 6200T - Sulfides Analyzer User Manual
Page 3
6200T Total Sulfur Analyzer
Configuration
Teledyne Analytical Instruments
iii
INFORMATION ABOUT THE SPECIFIC CONFIGURATION OF YOUR
MODEL 6200T TOTAL SULFUR ANALYZER
Selected Versions of the Model 6200T
Model 6200T— Standard Version
This Model 6200T Analyzer is a touch screen version designed for analyzing the total sulfur (TS)
concentration in a sample gas. The analyzer includes a thermal converter to oxidize sulfur bearing
molecules to SO
2
which is then analyzed by the analyzer. The converter has an Oxy-Flow Sensor that
provides an alarm in the event of a low flow in the combustion air inlet to the converter.
The analyzer is designed for positive pressure applications and is not equipped with an internal pump.
The instrument is fitted with standard span and zero valves for switching between sample and calibration
gas. Alarm relays are optional and if included, that option will be checked below.
Model 6200T — with Pump
This version is equipped with an internal pump and is designed for positive pressure applications.
Power Requirements
This Model 6200T is configured to operate from the following AC Power source:
100-120 VAC 60 Hz
220-240 VAC 60 Hz
100V 60 Hz
100-120 VAC 50 Hz
220-240 VAC 50 Hz
100V 50 Hz
Analog Output Signals
Analog output signals are available at A1 and A2 on the rear panel. This instrument is configured with
the following analog outputs:
A1: 4-20 mA
A2: 0-5 V
A2: 4-20 mA
Range Mode
The analyzer can be designed with a single or dual analysis ranges with auto-ranging or dual
independent ranges. This analyzer is configured with the following range mode:
Single Range:
Dual Range/Auto-ranging
Dual Range/Independent
Low
Range:
Low
Range:
High
Range:
High
Range: