Warning messages – Teledyne 6200T - Sulfides Analyzer User Manual
Page 77
6200T Total Sulfur Analyzer
Getting Started
Teledyne Analytical Instruments
77
3.4.2. Warning Messages
Because internal temperatures and other conditions may be outside the specified limits
during the analyzer’s warm-up period, the software will suppress most warning
conditions for 30 minutes after power up. If warning messages persist after the 60
minutes warm up period is over, investigate their cause using the troubleshooting
guidelines in Section 12.1.1.
To view and clear warning messages, press:
Figure 3-23:
Warning Messages
SEL
p-dF
DIGITAL FILTER
SET TO “5”
SEL
P-SL
LOWER LIMIT
SET TO “32” (32C)
SEL
P-SU
UPPER LIMIT
SET TO “1050” (1050C)
SEL
P-AL
ALARM TYPE2
SET TO “10”
SEL
P-AH
ALARM TYPE 1
SET TO “10”
SEL
P-An
HYTERESIS
SET TO “3”
SEL
P-dP
DECIMAL
LOCATION
SET TO “0”
SEL
PVOF
PROCESS
OFFSET
LEAVE AT “0”
SEL
SVOF
SET POINT
OFFSET
LEAVE AT “0”
SEL
P-F
SET TO “ºC”
(CENTIGRADE)
SEL
FUZZY
FUZZY LOGIC
SET TO “ON”