Teledyne 6200T - Sulfides Analyzer - Manual (Page 175)

6200T Total Sulfur Analyzer DAS and AICOM
Teledyne Analytical Instruments 175
7.4. Remote DAS Configuration via AICOM
Editing channels, parameters and triggering events as described in this section is
performed via the AICOM remote control program using the graphic interface similar to
the example shown in
Figure 7-14. Refer to Section 8 for details on remote access to the 6200T analyzer.
Figure 7-14: Sample AICOM User Interface for Configuring the DAS
Once a DAS configuration is edited (which can be done offline and without interrupting
DAS data collection), it is conveniently uploaded to the instrument and can be stored on
a computer for later review, alteration or documentation and archival. Refer to the
AICOM manual for details on these procedures. The AICOM user manual (Teledyne
Analytical Instruments’s P/N 039450000) is included in the AICOM installation file,
which can be downloaded at http://www.teledyne-api.com/software/apicom/.
Although Teledyne Analytical Instruments recommends the use of AICOM, the DAS
can also be accessed and configured through a terminal emulation program such as
HyperTerminal (refer to
Figure 7-15). However, all configuration commands must be created following a strict
syntax or be pasted in from of a text file, which was edited offline and then uploaded
through a specific transfer procedure.