Teledyne 6200T - Sulfides Analyzer - Manual (Page 237)

6200T Total Sulfur Analyzer Troubleshooting
Teledyen Analytical Instruments 237
12. TROUBLESHOOTING & SERVICE
This section contains a variety of methods for identifying and solving performance
problems with the analyzer.
Note: To support your understanding of the technical details of maintenance,
Section 13, Principles of Operation, provides information about how the
instrument works.
CAUTION
THE OPERATIONS OUTLINED IN THIS SECTION MUST BE PERFORMED BY
QUALIFIED MAINTENANCE PERSONNEL ONLY.
WARNING
RISK OF ELECTRICAL SHOCK
SOME OPERATIONS NEED TO BE CARRIED OUT WITH THE ANALYZER OPEN
AND RUNNING. EXERCISE CAUTION TO AVOID ELECTRICAL SHOCKS AND
ELECTROSTATIC OR MECHANICAL DAMAGE TO THE ANALYZER. DO NOT
DROP TOOLS INTO THE ANALYZER OR LEAVE THOSE AFTER YOUR
PROCEDURES. DO NOT SHORTEN OR TOUCH ELECTRIC CONNECTIONS WITH
METALLIC TOOLS WHILE OPERATING INSIDE THE ANALYZER. USE COMMON
SENSE WHEN OPERATING INSIDE A RUNNING ANALYZER.
Note
The front panel of the analyzer is hinged at the bottom and may be
opened to gain access to various components mounted on the panel
itself or located near the front of the instrument (such as the particulate
filter).
Remove the locking screw located at the right-hand side of the front
panel.
12.1. General Troubleshooting
The 6200T has been designed so that problems can be rapidly detected, evaluated and
repaired. During operation, it continuously performs diagnostic tests and provides the
ability to evaluate its key operating parameters without disturbing monitoring
operations.
The following table provides a general guide to troubleshooting the Model 6200T.
Problem Corrective Action
NO POWER:
Plugged in?
Switched on?
Circuit breaker Tripped?