Teledyne 6200T - Sulfides Analyzer User Manual
Page 331
6200T Total Sulfur Analyzer
ESD Primer
Teledyen Analytical Instruments
331
If you are at an anti-ESD workbench, lay the container down on the
conductive work surface while your wrist strap is connected to a ground
point.
In either case wait several seconds.
4. Place the item in the container.
5. Seal the container. If using a bag, fold the end over and fasten it with anti-ESD tape.
Folding the open end over isolates the component(s) inside from the effects
of static fields.
Leaving the bag open or simply stapling it shut without folding it closed
prevents the bag from forming a complete protective envelope around the
device.
6. Once you have arrived at your destination, allow any surface charges that may have
built up on the bag or bin during travel to dissipate:
Connect your wrist strap to ground.
If you are at the instrument rack, hold the bag in one hand while your wrist
strap is connected to a ground point.
If you are at a anti-ESD work bench, lay the container down on the
conductive work surface
In either case wait several seconds
7. Open
the
container.
14.5.4. Opening Shipments from Teledyne Analytical Instruments’s
Customer Service
Packing materials such as bubble pack and Styrofoam pellets are extremely efficient
generators of static electric charges. To prevent damage from ESD, Teledyne Analytical
Instruments ships all electronic components and assemblies in properly sealed anti-ESD
containers.
Static charges will build up on the outer surface of the anti-ESD container during
shipping as the packing materials vibrate and rub against each other. To prevent these
static charges from damaging the components or assemblies being shipped ensure that
you always unpack shipments from Teledyne Analytical Instruments’s Customer Service
by:
1. Opening the outer shipping box away from the anti-ESD work area.
2. Carry the still sealed ant-ESD bag, tube or bin to the anti-ESD work area.
3. Follow steps 6 and 7 of Section 14.5.3 above when opening the anti-ESD container at
the work station.
4. Reserve the anti-ESD container or bag to use when packing electronic components
or assemblies to be returned to Teledyne Analytical Instruments.
14.5.5. Packing Components for Return to Teledyne Analytical
Instruments’s Customer Service
ATTENTION – COULD DAMAGE INSTRUMENT AND VOID WARRANTY
Always pack electronic components and assemblies to be sent to Teledyne