Ce mark compliance, Emissions compliance, Safety compliance – Teledyne 6200T - Sulfides Analyzer User Manual
Page 38
Specifications
Model
6200T
Total Sulfur Analyzer
Teledyne Analytical Instruments
38
Dynamic span
OFF
Dynamic zero
OFF
Dilution factor
OFF
AutoCal
ON or OFF
Dual range
ON or OFF
Auto-range
ON or OFF
Temp/Pressure compensation ON
Under this designation, the analyzer may be operated with or without the following
optional equipment:
Rack mount with chassis slides
Rack mount without slides, ears only
Zero/span valve options.
Internal zero/span (IZS) option with either:
SO
2
permeation tube - 0.4ppm at 0.7 liter per minute; certified/uncertified,
or
SO
2
permeation tube - 0.8 ppm at 0.7 liter per minute; certified/uncertified.
Under the designation, the IZS option cannot be used as the source of
calibration
4-20mA isolated analog outputs
Status outputs
Control inputs
RS-232 output
Ethernet output
Zero air scrubber
4-20mA, isolated output
2.3. CE Mark Compliance
This section presents emissions and safety compliance information.
2.3.1. Emissions Compliance
The Teledyne UV Fluorescence SO
2
Analyzer 6200T was tested and found to be fully
compliant with:
EN61326 (1997 w/A1: 98) Class A, FCC Part 15 Subpart B Section 15.107 Class A,
ICES-003 Class A (ANSI C63.4 1992) & AS/NZS 3548 (w/A1 & A2; 97) Class A.
2.3.2. Safety Compliance
The Teledyne-Advanced Pollution Instrumentation UV Fluorescence SO
2
Analyzer
6200T was tested and found to be fully compliant with:
IEC 61010-1:2001,
Issued by CKC Laboratories on 4 April 2003, Report Number WO-80146.