IAI America REXT - Manual (Page 316)


Part 2 Startup Chapter
Chapter 5 Network Setup
290
Part 2 Startup Chapter
z Reference
Once the data has been transferred, the following screen opens.
You can check on this screen the PIO pattern number of the applicable controller you should set for the specified mode.
If the “Do not show this screen after the transfer” check box is selected in the bottom left-hand corner of the screen, this
screen will no longer appear from the next transfer.
Caution
If the firmware version of the Gateway R unit does not support any new function you have set by a corresponding
parameter, an attempt to transfer the parameters will cause one of the following messages to appear and the transfer will be
cancelled. In this case, correct the setting of the applicable parameter by referring to (5), “Other settings” on the following
page and transfer the parameters again.
The “2W modes” include the positioner 2 mode, solenoid valve mode 1 and solenoid valve mode 2.
-316-