IAI America REXT - Manual (Page 319)


Part 2 Startup Chapter
Chapter 5 Network Setup
293
Part 2 Startup Chapter
(iv) Unit of speed (Limited to the direct numerical specification (positioning) mode) ---
You can set either 1.0 mm/sec or 0.1 mm/sec as the unit of speed for axes for which the direct numerical
specification (positioning) mode is set. The factory setting is 1.0 mm/sec. (Firmware version 000C or later)
(v) ROBONET communication retry count --- You can set a desired number from 0 to 6 to specify how many times
ROBONET communication (communication between the ROBONET gateway and RACON or other unit) will be
retried if unsuccessful. The factory setting is 2. (Firmware version 000F or later)
Caution
[The unit of speed (limited to the direct numerical specification (positioning) mode) cannot be changed unless the direct
numerical specification (positioning) mode is set for at least one axis.
[3] When all special parameters have been set, click [Close] to close the screen. The following message appears.
Click [Yes] to transfer the parameters. If [No] is selected, the parameters will not be transferred and any changes you
have made to the parameters will not become effective.
-319-