LevelOne GTL-2691 - Manual (Page 1053)

C HAPTER 35 | Automatic Traffic Control Commands
SNMP Trap Commands
– 1053 –
snmp-server enable
port-traps atc
multicast-control-
apply
This command sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control and the apply timer expires. Use the
no form to disable this trap.
S YNTAX
[no] snmp-server enable port-traps atc multicast-control-apply
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (Ethernet)
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-control-apply
Console(config-if)#
R ELATED C OMMANDS
auto-traffic-control alarm-fire-threshold (1048)
auto-traffic-control apply-timer (1044)
snmp-server enable
port-traps atc
multicast-control-
release
This command sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been triggered and the
release timer expires. Use the no form to disable this trap.
S YNTAX
[no] snmp-server enable port-traps atc
multicast-control-release
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (Ethernet)
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-control-
release
Console(config-if)#
R ELATED C OMMANDS
auto-traffic-control alarm-clear-threshold (1047)
auto-traffic-control action (1046)
auto-traffic-control release-timer (1044)