LevelOne GTL-2691 - Manual (Page 1342)

C HAPTER 44 | CFM Commands
Link Trace Operations
– 1342 –
◆ When using the command line or web interface, the source MEP used
by to send a link trace message is chosen by the CFM protocol.
However, when using SNMP, the source MEP can be specified by the
user.
E XAMPLE
This example sends a link trace message to the specified MEP with a
maximum hop count of 25.
Console#linktrace ethernet dest-mep 2 md voip ma rd ttl 25
Console#
clear ethernet cfm
linktrace-cache
This command clears link trace messages logged on this device.
C OMMAND M ODE
Privileged Exec
E XAMPLE
Console#clear ethernet cfm linktrace-cache
Console#
show ethernet cfm
linktrace-cache
This command displays the contents of the link trace cache.
C OMMAND M ODE
Privileged Exec
E XAMPLE
Console#show ethernet cfm linktrace-cache
Hops MA IP / Alias Ingress MAC Ing. Action Relay
Forwarded Egress MAC Egr. Action
---- -------------- ----------------------- ----------------- ----------- -----
2 rd 192.168.0.6 00-12-CF-12-12-2D ingOk Hit
Not Forwarded
Console#
Table 174: show ethernet cfm linktrace-cache - display description
Field Description
Hops The number hops taken to reach the target MEP.
MA Name of the MA to which this device belongs.
IP/Alias IP address or alias of the target device’s CPU.
Forwarded Shows whether or not this link trace message was forwarded. A
message is not forwarded if received by the target MEP.
Ingress MAC MAC address of the ingress port on the target device.
Egress MAC MAC address of the egress port on the target device.