LevelOne GTL-2691 - Manual (Page 1274)

C HAPTER 42 | Multicast Filtering Commands
MLD (Layer 3)
– 1274 –
Query Interval : 125 sec
Query Max Response Time : 10 sec
Last Member Query Interval : 1 sec
Querier : ::
Joined Groups :
Static Groups :
Console#
ipv6 mld last-
member-query-
response-interval
This command configures the frequency at which to send MLD group-
specific or MLDv2 group-source-specific query messages in response to
receiving a group-specific or group-source-specific leave message from the
last known active host on the subnet. Use the no form to restore the
default setting.
S YNTAX
ipv6 mld last-member-query-response-interval seconds
no ipv6 mld last-member-query-response-interval
seconds - The frequency at which the switch sends group-specific or
group-source-specific queries upon receipt of a leave message.
(Range: 1-255 seconds)
D EFAULT S ETTING
10 (1 second)
C OMMAND M ODE
Interface Configuration (VLAN)
C OMMAND U SAGE
When the switch receives an MLD or MLDv2 leave message from a host
that wants to leave a multicast group, source or channel, it sends a
number of group-specific or group-source-specific query messages at
intervals defined by this command. If no response is received after this
period, the switch stops forwarding for the group, source or channel.
E XAMPLE
Console(config)#interface vlan 1
Console(config-if)#ipv6 mld last-member-query-response-interval 20
Console(config-if)#