LevelOne GTL-2691 - Manual (Page 1432)

C HAPTER 48 | IP Interface Commands
IPv6 Interface
– 1432 –
FF02::2
FF02::1:FF00:0
FF02::1:2
FF02::1:FF9C:CA10
FF02::1
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 2.
ND retransmit interval is 30000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
Console#
R ELATED C OMMANDS
show running-config (771)
ipv6 nd
reachable-time
This command configures the amount of time that a remote IPv6 node is
considered reachable after some reachability confirmation event has
occurred. Use the no form to restore the default setting.
S YNTAX
ipv6 nd reachable-time milliseconds
no ipv6 nd reachable-time
milliseconds - The time that a node can be considered reachable
after receiving confirmation of reachability.
(Range: 1000-3600000)
D EFAULT S ETTING
30000 milliseconds is used for neighbor discovery operations
0 milliseconds is advertised in router advertisements
C OMMAND M ODE
Interface Configuration (VLAN)
C OMMAND U SAGE
◆ The time limit configured by this command allows the router to detect
unavailable neighbors.
◆ This time limit is included in all router advertisements sent out through
an interface, ensuring that nodes on the same link use the same time
value.
◆ Setting the time limit to 0 means that the configured time is
unspecified by this router.