Ipv6 router ospf tag area, Ipv6 router ospf tag area (1530) – LevelOne GTL-2691 User Manual

Page 1530

Advertising
background image

C

HAPTER

49

| IP Routing Commands

Open Shortest Path First (OSPFv3)

– 1530 –

ipv6 router ospf tag

area

This command binds an OSPF area to the selected interface and process.

Use the no form to remove the specified area from an interface.

[no] ipv6 router ospf tag process-name area area-id

[instance-id instance-id]
area-id
- Area to bind to the current Layer 3 interface. An OSPF

area identifies a group of routers that share common routing

information. The area ID can be in the form of an IPv4 address or

as a four octet unsigned integer ranging from 0-4294967295.
process-name - A process name used to distinguish between

multiple routing instances configured on the local router.

(Range: Alphanumeric string up to 16 characters)
instance-id - Identifies a specific OSPFv3 routing process on the

link-local network segment attached to this interface.

(Range: 0-255)

C

OMMAND

M

ODE

Interface Configuration (VLAN)

D

EFAULT

S

ETTING

No areas are defined.

C

OMMAND

U

SAGE

◆

An area ID uniquely defines an OSPF broadcast area. The area ID

0.0.0.0 indicates the OSPF backbone for an autonomous system. Each

router must be connected to the backbone via a direct connection or a

virtual link.

◆

Set the area ID to the same value for all routers on a network segment.

◆

The process-name is only used on the local router to distinguish

between different routing processes (and must be configured with the

router ipv6 ospf

command before using it in this command.

◆

The instance-id is used on the link-local network segment to distinguish

between different routing processes running on the same link, and

allows routers participating in a common routing process to form

adjacencies and exchange routing information.

◆

The backbone (area 0.0.0.0) must be created before any other area.

E

XAMPLE

This example assigns area 0.0.0.1 to the currently selected interface under

routing process “1.”

Console(config)#interface vlan 1

Console(config-if)#ipv6 router ospf tag 1 area 0.0.0.1

Console(config-if)#

Advertising