Igmp snooping, Table 140: igmp snooping commands, Igmp s – LevelOne GTL-2691 User Manual
Page 1186: Nooping
C
HAPTER
42
| Multicast Filtering Commands
IGMP Snooping
– 1186 –
IGMP S
NOOPING
This section describes commands used to configure IGMP snooping on the
switch.
Table 140: IGMP Snooping Commands
Command
Function
Mode
Enables
IGMP
snooping
GC
Enables IGMP Snooping with Proxy Reporting
GC
Allows this device to act as the querier for IGMP
snooping
GC
Discards any IGMPv2/v3 packets that do not include
the Router Alert option
GC
Configures the querier timeout
GC
Floods multicast traffic when a Spanning Tree topology
change occurs
GC
Sends an IGMP Query Solicitation when a Spanning
Tree topology change occurs
GC
Floods unregistered multicast traffic into the attached
VLAN
GC
Specifies how often the upstream interface should
transmit unsolicited IGMP reports (when report
suppression/proxy reporting is enabled)
GC
Configures the IGMP version for snooping
GC
Discards received IGMP messages which use a version
different to that currently configured
GC
Suppresses general queries except for ports attached
to downstream multicast hosts
GC
Immediately deletes a member port of a multicast
service if a leave packet is received at that port and
immediate-leave is enabled for the parent VLAN
GC
Configures the number of IGMP proxy query messages
that are sent out before the system assumes there are
no local members
GC
Configures the last-member-query interval
GC
Sends multicast router solicitation messages
GC
Configures a static address for proxy IGMP query and
reporting
GC
Enables IGMP Snooping with Proxy Reporting
GC
Configures the interval between sending IGMP general
queries
GC
Configures the maximum time the system waits for a
response to general queries
GC
Adds an interface as a member of a multicast group
GC