LevelOne GTL-2691 - Manual (Page 728)

C HAPTER 21 | Multicast Routing
Configuring PIMv6 for IPv6
– 728 –
Figure 469: Showing RP Mapping
C ONFIGURING PIM V 6 FOR IP V 6
This section describes how to configure PIM-DM and PIM-SM for IPv6.
E NABLING PIM
G LOBALLY
Use the Routing Protocol > PIM6 > General page to enable IPv6 PIM
routing globally on the router.
CLI R EFERENCES
◆ "router pim6" on page 1577
C OMMAND U SAGE
◆ This feature enables PIM-DM and PIM-SM for IPv6 globally on the
router. You also need to enable PIM-DM and PIM-SM for each interface
that will support multicast routing (see page 729 ), and make any
changes necessary to the multicast protocol parameters.
◆ To use PIMv6, multicast routing must be enabled on the switch (see
"Enabling Multicast Routing Globally" on page 708 ).
◆ To use multicast routing, MLD proxy cannot enabled on any interface of
the device (see "MLD Proxy Routing" on page 1281 ).
W EB I NTERFACE
To enable PIMv6 multicast routing:
1.
Click Routing Protocol, PIM6, General.
2.
Enable PIM6 Routing Protocol.
3.
Click Apply.
Figure 470: Enabling PIMv6 Multicast Routing