Permit, deny, Range, Range 1210 – LevelOne GTL-2691 User Manual
Page 1210
C
HAPTER
42
| Multicast Filtering Commands
IGMP Filtering and Throttling
– 1210 –
permit, deny
This command sets the access mode for an IGMP filter profile. Use the no
form to delete a profile number.
S
YNTAX
{permit | deny}
D
EFAULT
S
ETTING
Deny
C
OMMAND
M
ODE
IGMP Profile Configuration
C
OMMAND
U
SAGE
◆
Each profile has only one access mode; either permit or deny.
◆
When the access mode is set to permit, IGMP join reports are
processed when a multicast group falls within the controlled range.
When the access mode is set to deny, IGMP join reports are only
processed when a multicast group is not in the controlled range.
E
XAMPLE
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#permit
Console(config-igmp-profile)#
range
This command specifies multicast group addresses for a profile. Use the no
form to delete addresses from a profile.
S
YNTAX
[no] range low-ip-address [high-ip-address]
low-ip-address - A valid IP address of a multicast group or start of a
group range.
high-ip-address - A valid IP address for the end of a multicast group
range.
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
IGMP Profile Configuration
C
OMMAND
U
SAGE
Enter this command multiple times to specify more than one multicast
address or address range for a profile.