LevelOne GTL-2691 - Manual (Page 508)

C HAPTER 14 | Basic Administration Protocols
Connectivity Fault Management
– 508 –
■
EgrVid – The Egress Port can be identified, but the bridge port is not
in the LTM’s VID member set, and was therefore filtered by egress
filtering.
◆ Reply – Reply action:
■
FDB – Target address found in forwarding database.
■
MPDB – Target address found in the maintenance point database.
■
HIT – Target located on this device.
W EB I NTERFACE
To show information about link trace operations launched from this device:
1. Click Administration, CFM.
2. Select Show Information from the Step list.
3. Select Show Link Trace Cache from the Action list.
Figure 286: Showing the Link Trace Cache
D ISPLAYING F AULT
N OTIFICATION
S ETTINGS
Use the Administration > CFM > Show Information (Show Fault Notification
Generator) page to display configuration settings for the fault notification
generator.
CLI R EFERENCES
◆ "show ethernet cfm fault-notify-generator" on page 1347
P ARAMETERS
These parameters are displayed:
◆ MEP ID – Maintenance end point identifier.
◆ MD Name – Maintenance domain name.
◆ MA Name – Maintenance association name.
◆ Highest Defect – The highest defect that will generate a fault alarm.
(This is disabled by default.)
◆ Lowest Alarm – The lowest defect that will generate a fault alarm 10 .