LevelOne GTL-2691 - Manual (Page 559)

C HAPTER 15 | Multicast Filtering
Multicast VLAN Registration
– 559 –
W EB I NTERFACE
To configure global settings for MVR:
1. Click Multicast, MVR.
2. Select Configure Domain from the Step list.
3. Select a domain from the scroll-down list.
4. Enable MVR for the selected domain, select the MVR VLAN, and set the
source IP address for all control packets sent upstream as required.
5. Click Apply.
Figure 327: Configuring Domain Settings for MVR
C ONFIGURING MVR
G ROUP A DDRESS
P ROFILES
Use the Multicast > MVR (Configure Profile and Associate Profile) pages to
assign the multicast group address for required services to one or more
MVR domains.
CLI R EFERENCES
◆ "MVR for IPv4" on page 1227
C OMMAND U SAGE
◆ Use the Configure Profile page to statically configure all multicast group
addresses that will join the MVR VLAN. Any multicast data associated
with an MVR group is sent from all source ports to all receiver ports that
have registered to receive data from that multicast group.
◆ The IP address range from 224.0.0.0 to 239.255.255.255 is used for
multicast streams. MVR group addresses cannot fall within the reserved
IP multicast address range of 224.0.0.x.
◆ IGMP snooping and MVR share a maximum number of 1024 groups.
Any multicast streams received in excess of this limitation will be
flooded to all ports in the associated domain.