LevelOne GTL-2691 - Manual (Page 1415)

C HAPTER 48 | IP Interface Commands
IPv6 Interface
– 1415 –
Link-local address:
FE80::200:E8FF:FE93:82A0/64
Global unicast address(es):
2001:DB8:2222:7272::72/96, subnet is 2001:DB8:2222:7272::/96
Joined group address(es):
FF02::1:2
FF02::1:FF00:72
FF02::1:FF00:0
FF02::1:FF93:82A0
FF02::1
IPv6 link MTU is 1280 bytes
ND DAD is enabled, number of DAD attempts: 2.
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
Console#
R ELATED C OMMANDS
ipv6 address link-local (1413)
show ipv6 interface (1416)
ipv6 mtu This command sets the size of the maximum transmission unit (MTU) for
IPv6 packets sent on an interface. Use the no form to restore the default
setting.
S YNTAX
ipv6 mtu size
no ipv6 mtu
size - Specifies the MTU size. (Range: 1280-65535 bytes)
D EFAULT S ETTING
1500 bytes
C OMMAND M ODE
Interface Configuration (VLAN)
C OMMAND U SAGE
◆ The maximum value set by this command cannot exceed the MTU of
the physical interface, which is currently fixed at 1500 bytes.
◆ If a non-default value is configured, an MTU option is included in the
router advertisements sent from this device.
◆ IPv6 routers do not fragment IPv6 packets forwarded from other
routers. However, traffic originating from an end-station connected to
an IPv6 router may be fragmented.
◆ All devices on the same physical medium must use the same MTU in
order to operate correctly.