Configuring vlan interfaces, Interface vlan, Configuring vlan – LevelOne GTL-2691 User Manual
Page 1115: Interfaces, Vlan i, Onfiguring, Nterfaces
C
HAPTER
39
| VLAN Commands
Configuring VLAN Interfaces
– 1115 –
E
XAMPLE
The following example adds a VLAN, using VLAN ID 105 and name RD5.
The VLAN is activated by default.
Console(config)#vlan database
Console(config-vlan)#vlan 105 name RD5 media ethernet
Console(config-vlan)#
R
ELATED
C
OMMANDS
C
ONFIGURING
VLAN I
NTERFACES
interface vlan
This command enters interface configuration mode for VLANs, which is
used to configure VLAN parameters for a physical interface. Use the no
form to change a Layer 3 normal VLAN back to a Layer 2 interface.
S
YNTAX
[no] interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4093)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
Table 122: Commands for Configuring VLAN Interfaces
Command
Function
Mode
Enters interface configuration mode for a specified
VLAN
GC
Configures frame types to be accepted by an interface IC
Configures the VLANs associated with an interface
IC
Configures forbidden VLANs for an interface
IC
Enables GVRP for an interface
IC
Enables ingress filtering on an interface
IC
Configures VLAN membership mode for an interface
IC
Configures the PVID (native VLAN) of an interface
IC
Sets a port priority for incoming untagged frames
IC
Allows unknown VLANs to cross the switch
IC