LevelOne GTL-2691 - Manual (Page 635)

C HAPTER 18 | General IP Routing
Displaying the Routing Table
– 635 –
Figure 389: Configuring Static Routes
To display static routes:
1. Click IP, Routing, Static Routes.
2. Select Show from the Action List.
Figure 390: Displaying Static Routes
D ISPLAYING THE R OUTING T ABLE
Use the IP > Routing > Routing Table (Show Information) page to display
all routes that can be accessed via local network interfaces, through static
routes, or through a dynamically learned route. If route information is
available through more than one of these methods, the priority for route
selection is local, static, and then dynamic (except when the distance
parameter of a dynamic route is set to a value that makes its priority
exceed that of a static route). Also note that the route for a local interface
is not enabled (i.e., listed in the routing table) unless there is at least one
active link connected to that interface.
CLI R EFERENCES
◆ "show ip route" on page 1450
C OMMAND U SAGE
◆ The Forwarding Information Base (FIB) contains information required
to forward IP traffic. It contains the interface identifier and next hop
information for each reachable destination network prefix based on the
IP routing table. When routing or topology changes occur in the