LevelOne GTL-2691 - Manual (Page 725)

C HAPTER 21 | Multicast Routing
Configuring PIM for IPv4
– 725 –
Figure 466: Configuring an RP Candidate
To display settings for an RP candidate:
1. Click Multicast, Multicast Routing, PIM-SM.
2. Select RP Candidate from the Step list.
3. Select Show from the Action list.
4. Select an interface from the VLAN list.
Figure 467: Showing Settings for an RP Candidate
D ISPLAYING THE BSR
R OUTER
Use the Routing Protocol > PIM > SM (Show Information – Show BSR
Router) page to display Information about the bootstrap router (BSR).
CLI R EFERENCES
◆ "show ip pim bsr-router" on page 1573
P ARAMETERS
These parameters are displayed:
◆ IP Address – IP address of interface configured as the BSR.
◆ Uptime – The time this BSR has been up and running.