LevelOne GTL-2691 - Manual (Page 1093)

C HAPTER 38 | ERPS Commands
– 1093 –
enable This command activates the current ERPS ring. Use the no form to disable
the current ring.
S YNTAX
[no] enable
D EFAULT S ETTING
Disabled
C OMMAND M ODE
ERPS Configuration
C OMMAND U SAGE
◆ Before enabling a ring, the global ERPS function should be enabled with
the erps command, the east and west ring ports configured on each
node with the ring-port command, the RPL owner specified with the rpl
owner command, and the control VLAN configured with the control-vlan
command.
◆ Once enabled, the RPL owner node and non-owner node state machines
will start, and the ring will enter idle state if no signal failures are
detected.
E XAMPLE
Console(config-erps)#enable
Console(config-erps)#
R ELATED C OMMANDS
erps (1091)
guard-timer This command sets the guard timer to prevent ring nodes from receiving
outdated R-APS messages. Use the no form to restore the default setting.
S YNTAX
guard-timer milliseconds
milliseconds - The guard timer is used to prevent ring nodes from
receiving outdated R-APS messages. During the duration of the
guard timer, all received R-APS messages are ignored by the ring
protection control process, giving time for old messages still
circulating on the ring to expire. (Range: 10-2000 milliseconds, in
steps of 10 milliseconds)
D EFAULT S ETTING
500 milliseconds
C OMMAND M ODE
ERPS Configuration