LevelOne GTL-2691 - Manual (Page 886)

C HAPTER 28 | Authentication Commands
Web Server
– 886 –
C OMMAND U SAGE
◆ Both HTTP and HTTPS service can be enabled independently on the
switch. However, you cannot configure the HTTP and HTTPS servers to
use the same UDP port.
◆ If you enable HTTPS, you must indicate this in the URL that you specify
in your browser: https://device[:port_number]
◆ When you start HTTPS, the connection is established in this way:
■
The client authenticates the server using the server’s digital
certificate.
■
The client and server negotiate a set of security protocols to use for
the connection.
■
The client and server generate session keys for encrypting and
decrypting data.
◆ The client and server establish a secure encrypted connection.
A padlock icon should appear in the status bar for Internet Explorer 5.0
or above, and Mozilla Firefox 2.0 or above.
The following web browsers and operating systems currently support
HTTPS:
◆ To specify a secure-site certificate, see “Replacing the Default Secure-
site Certificate” on page 341 . Also refer to the copy tftp https-certificate
command.
E XAMPLE
Console(config)#ip http secure-server
Console(config)#
R ELATED C OMMANDS
ip http secure-port (885)
copy tftp https-certificate ( 780 )
show system (773)
Table 75: HTTPS System Support
Web Browser Operating System
Internet Explorer 5.0 or later Windows 98,Windows NT (with service pack 6a),
Windows 2000, XP, 7, 8
Mozilla Firefox 2.0 or later Windows 2000, XP, 7, 8, and Linux