LevelOne GTL-2691 - Manual (Page 1300)

C HAPTER 43 | LLDP Commands
– 1300 –
C OMMAND U SAGE
◆ This option sends out SNMP trap notifications to designated target
stations at the interval specified by the lldp notification-interval
command. Trap notifications include information about state changes in
the LLDP MIB (IEEE 802.1AB), the LLDP-MED MIB (ANSI/TIA 1057), or
organization-specific LLDP-EXT-DOT1 and LLDP-EXT-DOT3 MIBs.
◆ SNMP trap destinations are defined using the snmp-server host
command ( page 833 ).
◆ Information about additional changes in LLDP neighbors that occur
between SNMP notifications is not transmitted. Only state changes that
exist at the time of a trap notification are included in the transmission.
An SNMP agent should therefore periodically check the value of
lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.
E XAMPLE
ES-3026(config)#interface ethernet 1/1
ES-3026(config-if)#lldp med-notification
ES-3026(config-if)#
lldp med-tlv
inventory
This command configures an LLDP-MED-enabled port to advertise its
inventory identification details. Use the no form to disable this feature.
S YNTAX
[no] lldp med-tlv inventory
D EFAULT S ETTING
Enabled
C OMMAND M ODE
Interface Configuration (Ethernet, Port Channel)
C OMMAND U SAGE
This option advertises device details useful for inventory management,
such as manufacturer, model, software version and other pertinent
information.
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp med-tlv inventory
Console(config-if)#