LevelOne GTL-2691 - Manual (Page 771)

C HAPTER 24 | System Management Commands
System Status
– 771 –
show running-
config
This command displays the configuration information currently in use.
S YNTAX
show running-config [interface interface]
interface
ethernet unit/port
unit - Stack unit. (Range: 1-8)
port - Port number. (Range: 1-26)
port-channel channel-id (Range: 1-32)
vlan vlan-id (Range: 1-4093)
C OMMAND M ODE
Privileged Exec
C OMMAND U SAGE
◆ Use the interface keyword to display configuration data for the
specified interface.
◆ Use this command in conjunction with the show startup-config
command to compare the information in running memory to the
information stored in non-volatile memory.
◆ This command displays settings for key command modes. Each mode
group is separated by “!” symbols, and includes the configuration mode
command, and corresponding commands. This command displays the
following information:
■
MAC address for each switch in the stack
■
SNMP community strings
■
Users (names, access levels, and encrypted passwords)
■
VLAN database (VLAN ID, name and state)
■
VLAN configuration settings for each interface
■
Multiple spanning tree instances (name and interfaces)
■
IP address configured for VLANs
■
Layer 4 precedence settings
■
Routing protocol configuration settings
■
Spanning tree settings
■
Interface settings
■
Any configured settings for the console port and Telnet
E XAMPLE
Console#show running-config
Building running configuration. Please wait...
!<stackingDB>0000000000000000</stackingDB>
!<stackingMac>01_00-00-e8-93-82-a0_01</stackingMac>
!<stackingMac>00_00-00-00-00-00-00_00</stackingMac>
!<stackingMac>00_00-00-00-00-00-00_00</stackingMac>
!<stackingMac>00_00-00-00-00-00-00_00</stackingMac>
!<stackingMac>00_00-00-00-00-00-00_00</stackingMac>
!<stackingMac>00_00-00-00-00-00-00_00</stackingMac>