LevelOne GTL-2691 - Manual (Page 1336)

C HAPTER 44 | CFM Commands
Cross Check Operations
– 1336 –
mep-unknown – Sends a trap if an unconfigured MEP comes up.
D EFAULT S ETTING
All continuity checks are enabled.
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ For this trap type to function, cross-checking must be enabled on the
required maintenance associations using the ethernet cfm mep
crosscheck command.
◆ A mep-missing trap is sent if cross-checking is enabled (with the
ethernet cfm mep crosscheck command), and no CCM is received for a
remote MEP configured in the static list (with the mep crosscheck mpid
command).
◆ A mep-unknown trap is sent if cross-checking is enabled, and a CCM is
received from a remote MEP that is not configured in the static list.
◆ A ma-up trap is sent if cross-checking is enabled, and a CCM is received
from all remote MEPs configured in the static list for this maintenance
association.
E XAMPLE
This example enables SNMP traps for mep-unknown events detected in
cross-check operations.
Console(config)#snmp-server enable traps ethernet cfm crosscheck mep-unknown
Console(config)#
mep crosscheck
mpid
This command statically defines a remote MEP in a maintenance
association. Use the no form to remove a remote MEP.
S YNTAX
[no] mep crosscheck mpid mpid ma ma-name
mpid – Identifier for a maintenance end point which exists on
another CFM-enabled device within the same MA. (Range: 1-8191)
ma-name – Maintenance association name. (Range: 1-44
alphanumeric characters)
D EFAULT S ETTING
No remote MEPs are configured.
C OMMAND M ODE
CFM Domain Configuration