LevelOne GTL-2691 - Manual (Page 161)

– 161 –
5
I
NTERFACE
C
ONFIGURATION
This chapter describes the following topics:
◆ Port Configuration – Configures connection settings, including auto-
negotiation, or manual setting of speed, duplex mode, and flow control.
◆ Port Mirroring – Sets the source and target ports for mirroring on the
local switch.
◆ Displaying Statistics – Shows Interface, Etherlike, and RMON port
statistics in table or chart form.
◆ Cable Test – Performs cable diagnostics on the specified port.
◆ Trunk Configuration – Configures static or dynamic trunks.
◆ Flow Sampling – Configures periodic sampling of traffic flows.
◆ Traffic Segmentation – Configures the uplinks and down links to a
segmented group of ports.
◆ VLAN Trunking – Configures a tunnel across one or more intermediate
switches which pass traffic for VLAN groups to which they do not
belong.
P ORT C ONFIGURATION
This section describes how to configure port connections, mirror traffic
from one port to another, and run cable diagnostics.
C ONFIGURING BY
P ORT L IST
Use the Interface > Port > General (Configure by Port List) page to enable/
disable an interface, set auto-negotiation and the interface capabilities to
advertise, or manually fix the speed, duplex mode, and flow control.
CLI R EFERENCES
◆ "Interface Commands" on page 997
C OMMAND U SAGE
◆ Auto-negotiation must be disabled before you can configure or force a
Gigabit RJ-45 interface to use the Speed/Duplex mode or Flow Control
options.