LevelOne GTL-2691 - Manual (Page 494)

C HAPTER 14 | Basic Administration Protocols
Connectivity Fault Management
– 494 –
Figure 276: Configuring Remote Maintenance End Points
To show the configured remote maintenance end points:
1. Click Administration, CFM.
2. Select Configure MEP from the Step list.
3. Select Show from the Action list.
4. Select an entry from MD Index and MA Index.
Figure 277: Showing Remote Maintenance End Points
T RANSMITTING L INK
T RACE M ESSAGES
Use the Administration > CFM (Transmit Link Trace) page to transmit link
trace messages (LTMs). These messages can isolate connectivity faults by
tracing the path through a network to the designated target node (i.e., a
remote maintenance end point).
CLI R EFERENCES
◆ "CFM Commands" on page 1309
C OMMAND U SAGE
◆ LTMs can be targeted to MEPs, not MIPs. Before sending a link trace
message, be sure you have configured the target MEP for the specified
MA (see "Configuring Remote Maintenance End Points" ).
◆ If the MAC address of target MEP has not been learned by any local
MEP, then the linktrace may fail. Use the Show Information (Show
Remote MEP) page to verify that a MAC address has been learned for
the target MEP.