Ipv6 nd ns-interval, Ipv6 nd ns-interval (1431) – LevelOne GTL-2691 User Manual

Page 1431

Advertising
background image

C

HAPTER

48

| IP Interface Commands

IPv6 Interface

– 1431 –

E

XAMPLE

The following tells hosts to use stateful autoconfiguration to obtain other

non-address information from a DHCPv6 server:

Console(config)#interface vlan 1

Console(config)#ipv6 nd other-config-flag

Console(config)#

ipv6 nd ns-interval

This command configures the interval between transmitting IPv6 neighbor

solicitation messages on an interface. Use the no form to restore the

default value.

S

YNTAX

ipv6 nd ns-interval milliseconds
no ipv6 nd ns-interval

milliseconds - The interval between transmitting IPv6 neighbor

solicitation messages. (Range: 1000-3600000)

D

EFAULT

S

ETTING

1000 milliseconds is used for neighbor discovery operations

0 milliseconds is advertised in router advertisements

C

OMMAND

M

ODE

Interface Configuration (VLAN)

C

OMMAND

U

SAGE

◆

When a non-default value is configured, the specified interval is used

both for router advertisements and by the router itself.

◆

This command specifies the interval between transmitting neighbor

solicitation messages when resolving an address, or when probing the

reachability of a neighbor. Therefore, avoid using very short intervals

for normal IPv6 operations.

E

XAMPLE

The following sets the interval between sending neighbor solicitation

messages to 30000 milliseconds:

Console(config)#interface vlan 1

Console(config)#ipv6 nd ns-interval 30000

Console(config)#end

Console#show ipv6 interface

VLAN 1 is up

IPv6 is enabled.

Link-local address:

FE80::2E0:CFF:FE9C:CA10/64

Global unicast address(es):

2001:DB8:2222:7272::/64, subnet is 2001:DB8:2222:7272::/64

2009:DB9:2229::79, subnet is ::

Joined group address(es):

Advertising