LevelOne GTL-2691 - Manual (Page 598)

C HAPTER 17 | IP Services
Domain Name Service
– 598 –
Figure 354: Showing the List of Domain Names for DNS
C ONFIGURING A L IST
OF N AME S ERVERS
Use the IP Service > DNS - General (Add Name Server) page to configure a
list of name servers to be tried in sequential order.
CLI R EFERENCES
◆ "ip name-server" on page 1355
◆ "show dns" on page 1357
C OMMAND U SAGE
◆ To enable DNS service on this switch, configure one or more name
servers, and enable domain lookup status (see "Configuring General
DNS Service Parameters" on page 595 ).
◆ When more than one name server is specified, the servers are queried
in the specified sequence until a response is received, or the end of the
list is reached with no response.
◆ If all name servers are deleted, DNS will automatically be disabled. This
is done by disabling the domain lookup status.
P ARAMETERS
These parameters are displayed:
Name Server IP Address – Specifies the address of a domain name
server to use for name-to-address resolution. Up to six IP addresses can be
added to the name server list.
W EB I NTERFACE
To create a list name servers:
1.
Click IP Service, DNS.
2.
Select Add Name Server from the Action list.
3.
Enter one name server at a time.
4.
Click Apply.