LevelOne GTL-2691 - Manual (Page 708)

C HAPTER 21 | Multicast Routing
Configuring Global Settings for Multicast Routing
– 708 –
data transmission delays. The switch can also be configured to use SPT
only for specific multicast groups, or to disable the change over to SPT for
specific groups.
C ONFIGURING G LOBAL S ETTINGS FOR M ULTICAST R OUTING
To use multicast routing on this router, first globally enable multicast
routing as described in this section, then specify the interfaces that will
employ multicast routing protocols (PIM-DM or PIM-SM for IPv4 on
page 712 , or PIM-DM for IPv6 on page 728 ). Note that only one IPv4
multicast routing protocol (PIM-DM or PIM-SM) can be enabled on any
given interface, but both PIMv4 and PIMv6 can be enabled on the same
interface.
E NABLING M ULTICAST
R OUTING G LOBALLY
Use the Multicast > Multicast Routing > General page to enable IP
multicast routing globally on the switch.
CLI R EFERENCES
◆ "ip multicast-routing" on page 1545
P ARAMETERS
These parameters are displayed:
◆ Multicast Forwarding Status – Enables IP multicast routing.
(Default: Disabled)
W EB I NTERFACE
To enable multicast routing:
1. Click Multicast, Multicast Routing, General.
2.
Enable Multicast Forwarding Status.
3.
Click Apply.
Figure 455: Enabling Multicast Routing