LevelOne GTL-2691 - Manual (Page 761)

C HAPTER 23 | General Commands
– 761 –
C OMMAND U SAGE
◆ This command resets the entire system.
◆ Any combination of reload options may be specified. If the same option
is re-specified, the previous setting will be overwritten.
◆ When the system is restarted, it will always run the Power-On Self-Test.
It will also retain all configuration information stored in non-volatile
memory by the copy running-config startup-config command (See
"copy" on page 780 ).
E XAMPLE
This example shows how to reset the switch after 30 minutes:
Console(config)#reload in minute 30
***
*** --- Rebooting at January 1 02:10:43 2007 ---
***
Are you sure to reboot the system at the specified time? <y/n>
enable This command activates Privileged Exec mode. In privileged mode,
additional commands are available, and certain commands display
additional information. See "Understanding Command Modes" on
page 752 .
S YNTAX
enable [level]
level - Privilege level to log into the device.
The device has two predefined privilege levels: 0: Normal Exec,
15: Privileged Exec. Enter level 15 to access Privileged Exec mode.
D EFAULT S ETTING
Level 15
C OMMAND M ODE
Normal Exec
C OMMAND U SAGE
◆ “super” is the default password required to change the command mode
from Normal Exec to Privileged Exec. (To set this password, see the
enable password command.)
◆ The “#” character is appended to the end of the prompt to indicate that
the system is in privileged access mode.