LevelOne GTL-2691 - Manual (Page 119)

C HAPTER 3 | Using the Web Interface
Navigating the Web Browser Interface
– 119 –
Show Fault Notification Generator Displays configuration settings for the fault notification generator 508
Show Continuity Check Error Displays CFM continuity check errors logged on this device 509
IP
General
Routing Interface
Add Address Configures an IP interface for a VLAN 573
Configure Interface Submits a DHCP request for additional information from a VLAN
interface configured with a static IPv4 address
577
Show Address Shows the IP interfaces assigned to a VLAN 573
Ping Sends ICMP echo request packets to another node on the network 625
Trace Route Shows the route packets take to the specified
destination 626
ARP Address Resolution Protocol 627
Configure General Sets the protocol timeout, and enables or disables proxy ARP for
the specified VLAN
628
Configure Static Address 630
Add Statically maps a physical address to an IP address 630
Show Shows the MAC to IP address static table 630
Show Information
Dynamic Address Shows dynamically learned entries in the IP routing table 632
Other Address Shows internal addresses used by the switch 632
Statistics Shows statistics on ARP requests sent and received 633
Routing
Static Routes 633
Add Configures static routing entries 633
Show Shows static routing entries 633
Modify Modifies the selected static routing entry 633
Routing Table
Show Information Shows all routing entries, including local, static and dynamic
routes
635
Configure ECMP Number Sets the maximum number of equal-cost paths to the same
destination that can be installed in the routing table
637
VRRP Virtual Router Redundancy Protocol 639
Configure Group ID 640
Add Adds a VRRP group identifier to a VLAN 640
Show Shows the VRRP group identifier list 640
Add IP Address Sets a virtual interface address for a VRRP group 640
Show IP Addresses Shows the virtual interface address assigned to a VRRP group 640
Table 6: Switch Main Menu (Continued)
Menu Description Page