Configuring pim for ipv4, Enabling pim globally, Configuring pim interface settings – LevelOne GTL-2691 User Manual

Page 712: Figure 458: enabling pim multicast routing

Advertising
background image

C

HAPTER

21

| Multicast Routing

Configuring PIM for IPv4

– 712 –

C

ONFIGURING

PIM

FOR

IP

V

4

This section describes how to configure PIM-DM and PIM-SM for IPv4.

E

NABLING

PIM

G

LOBALLY

Use the Routing Protocol > PIM > General page to enable IPv4 PIM routing

globally on the router.

CLI R

EFERENCES

◆

"router pim" on page 1554

C

OMMAND

U

SAGE

◆

This feature enables PIM-DM and PIM-SM globally for the router. You

also need to enable PIM-DM or PIM-SM for each interface that will

support multicast routing (see

page 712

), and make any changes

necessary to the multicast protocol parameters.

◆

To use PIM, multicast routing must be enabled on the switch (see

"Enabling Multicast Routing Globally" on page 708

).

W

EB

I

NTERFACE

To enable PIM multicast routing:

1.

Click Routing Protocol, PIM, General.

2.

Enable PIM Routing Protocol.

3.

Click Apply.

Figure 458: Enabling PIM Multicast Routing

C

ONFIGURING

PIM

I

NTERFACE

S

ETTINGS

Use the Routing Protocol > PIM > Interface page configure the routing

protocol’s functional attributes for each interface.

CLI R

EFERENCES

◆

"IPv4 PIM Commands" on page 1553

C

OMMAND

U

SAGE

◆

Most of the attributes on this page are common to both PIM-DM and

PIM-SM. Select Dense or Sparse Mode to display the common

attributes, as well as those applicable to the selected mode.

Advertising