Resetting the system, Figure 25: renumbering the stack – LevelOne GTL-2691 User Manual
Page 157
C
HAPTER
4
| Basic Management Tasks
Resetting the System
– 157 –
Master unit is taken as the top of the stack and is numbered as unit 1,
and all other units are numbered sequentially down through the ring.
W
EB
I
NTERFACE
To renumber the units in the stack:
1.
Click System, then Renumber.
2.
Click OK when the confirmation message appears.
Figure 25: Renumbering the Stack
R
ESETTING
THE
S
YSTEM
Use the System > Reset menu to restart the switch immediately, at a
specified time, after a specified delay, or at a periodic interval.
CLI R
EFERENCES
◆
"reload (Privileged Exec)" on page 764
◆
"reload (Global Configuration)" on page 760
◆
C
OMMAND
U
SAGE
◆
This command resets the entire system.
◆
When the system is restarted, it will always run the Power-On Self-Test.
It will also retain all configuration information stored in non-volatile
memory by the
running-config startup-config
command (See