LevelOne GTL-2691 - Manual (Page 1261)

C HAPTER 42 | Multicast Filtering Commands
IGMP (Layer 3)
– 1261 –
Specific Query Sent : 0
Number of Reports Sent : 2
Number of Leaves Sent : 0
Console#
IGMP (L AYER 3)
This section describes commands used to configure Layer 3 Internet Group
Management Protocol (IGMP) on the switch.
ip igmp This command enables IGMP on a VLAN interface. Use the no form of this
command to disable IGMP on the specified interface.
S YNTAX
[no] ip igmp
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (VLAN)
C OMMAND U SAGE
◆ IGMP (including query functions) can be enabled for specific VLAN
interfaces at Layer 3 through the ip igmp command.
◆ When a multicast routing protocol, such as PIM, is enabled, IGMP is
also enabled.
Table 160: IGMP Commands (Layer 3)
Command Function Mode
ip igmp Enables IGMP for the specified interface IC
ip igmp last-member-
query-interval
Configures the frequency at which to send query
messages in response to receiving a leave message
IC
ip igmp max-resp-interval Configures the maximum host response time IC
ip igmp query-interval Configures frequency for sending host query messages IC
ip igmp robustval Configures the expected packet loss IC
ip igmp static-group Configures the router to be a static member of a
multicast group on the specified VLAN interface
IC
ip igmp version Configures IGMP version used on this interface IC
clear ip igmp group Deletes entries from the IGMP cache PE
show ip igmp groups Displays information for IGMP groups PE
show ip igmp interface Displays multicast information for the specified
interface
PE