LevelOne GTL-2691 - Manual (Page 1211)

C HAPTER 42 | Multicast Filtering Commands
IGMP Filtering and Throttling
– 1211 –
E XAMPLE
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#range 239.1.1.1
Console(config-igmp-profile)#range 239.2.3.1 239.2.3.100
Console(config-igmp-profile)#
ip igmp filter
(Interface
Configuration)
This command assigns an IGMP filtering profile to an interface on the
switch. Use the no form to remove a profile from an interface.
S YNTAX
[no] ip igmp filter profile-number
profile-number - An IGMP filter profile number.
(Range: 1-4294967295)
D EFAULT S ETTING
None
C OMMAND M ODE
Interface Configuration
C OMMAND U SAGE
◆ The IGMP filtering profile must first be created with the ip igmp profile
command before being able to assign it to an interface.
◆ Only one profile can be assigned to an interface.
◆ A profile can also be assigned to a trunk interface. When ports are
configured as trunk members, the trunk uses the filtering profile
assigned to the first port member in the trunk.
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#ip igmp filter 19
Console(config-if)#
ip igmp max-groups This command sets the IGMP throttling number for an interface on the
switch. Use the no form to restore the default setting.
S YNTAX
ip igmp max-groups number
no ip igmp max-groups
number - The maximum number of multicast groups an interface
can join at the same time. (Range: 1-1024)