Mvr vlan group – LevelOne GTL-2691 User Manual

Page 1237

Advertising
background image

C

HAPTER

42

| Multicast Filtering Commands

MVR for IPv4

– 1237 –

mvr vlan group

This command statically binds a multicast group to a port which will receive

long-term multicast streams associated with a stable set of hosts. Use the

no form to restore the default settings.

S

YNTAX

[no] mvr [domain domain-id] vlan vlan-id group ip-address

domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Receiver VLAN to which the specified multicast traffic is

flooded. (Range: 1-4093)
group - Defines a multicast service sent to the selected port.
ip-address - Statically configures an interface to receive multicast

traffic from the IPv4 address specified for an MVR multicast group.

(Range: 224.0.1.0 - 239.255.255.255)

D

EFAULT

S

ETTING

No receiver port is a member of any configured multicast group.

C

OMMAND

M

ODE

Interface Configuration (Ethernet, Port Channel)

C

OMMAND

U

SAGE

◆

Multicast groups can be statically assigned to a receiver port using this

command.

◆

The IP address range from 224.0.0.0 to 239.255.255.255 is used for

multicast streams. MVR group addresses cannot fall within the reserved

IP multicast address range of 224.0.0.x.

◆

Only IGMP version 2 or 3 hosts can issue multicast join or leave

messages. If MVR must be configured for an IGMP version 1 host, the

multicast groups must be statically assigned using the mvr vlan group

command.

◆

The MVR VLAN cannot be specified as the receiver VLAN for static

bindings.

E

XAMPLE

The following statically assigns a multicast group to a receiver port:

Console(config)#interface ethernet 1/7

Console(config-if)#mvr domain 1 type receiver

Console(config-if)#mvr domain 1 vlan 3 group 225.0.0.5

Console(config-if)#

Advertising